If B had Π before him, there is nothing to explain his most unusual procedure.
The negative and equalizer terminals are located at the cab end of the car and are arranged so that connection can be easily made from them to the ground and, if necessary, to an equalizer circuit.
General Electric equalizer regulator designed to equalize the load on two machines, and diagram of connections.
Usually the negative and equalizer switches, and the field break-up switch are mounted on the frame of the converter.
The double pole equalizer switch 6S should now be closed, connecting the two field windings in parallel and equalizing the compounding, so that any variations of load will affect the two alternators equally.
In multipolar machines what points are connected by equalizer rings?
By means of leads, equalizer rings connect points of equal potential in the winding and so preserve an equalization of current.
Interest is therefore the equalizer of the value of things in different periods.
The enterpriser is merely the distributor or equalizer of cost among all the different products for which different agents can be used.
Sidenote: Interest is the equalizer of time values] 3.
Attaching the tension-equalizer directly to the calorimeter obviates the necessity for this drying process and hence the sulphuric-acid vessel has been discarded.
Formerly this section also included the tension-equalizer, but very recently we have in both of the calorimeters attached the tension-equalizer directly to the respiration chamber.
This is done by closing the valve connecting the tension-equalizer with the system and admitting oxygen to the tension-equalizer until the petroleum manometer shows a definite tension.
To make the control perfectly automatic, the apparatus shown on the top of the tension-equalizer J is employed.
To maintain the apparent volume of air through the whole system constant, oxygen is admitted into the tension-equalizer until the same tension is exerted on this part of the system at the end as at the beginning.
The heating was done by passing the current through an electric lamp placed in the cross immediately below the tension equalizer J.
Furthermore, the apparent volume of air in the tension-equalizer is arbitrarily adjusted to be the same amount at the end of each period by closing the valve and introducing oxygen until the tension is the same.
That is to say, with the method now in use it is necessary to fill the tension-equalizer to a definite pressure immediately at the end of each experimental period.
Accordingly the apparatus has been modified so that at present the tension-equalizer is attached directly to the wall of the calorimeter independent of the air-pipe.
Diagram showing dynamotor connections when used as an equalizer in the three wire system.
How is the dynamotor used as an equalizer in the three wire system?
Then close the positive and equalizer switches, thus allowing a part of the current from the other dynamo to pass through the equalizer connection and through the series field winding of No.
The usual practice is to connect the equalizer and the series field to the positive terminal, though if desired, they may be connected to the negative terminal; both however, must be connected to the same terminal.
One of these leads through its own field, and the other, by means of the equalizer bar, through the fields of the other dynamo.
The positive and equalizer switches of each machine differ in pressure only by the slight drop in the series coil, and in some large stations these two switches are placed side by side on a pedestal near the machine.
The resistance of the equalizer should be as low as possible, and it must never be greater than the resistance of any of the leads from the dynamos to the bus bar.
The equalizer is connected direct to the positive brushes of all the dynamos, a three pole switch being fitted for disconnecting it from the circuit when the machine to which it is connected is not working.
When compound wound dynamos are operated in parallel, the equalizer bar insures uniform distribution among the series coils of the machines.
This is known as the equalizer and is shown by the line running to the middle pole of the dynamo switch.
The equalizer may then be called upon to carry much current, but to have the machines regulate closely it should be of low resistance.
What should be done if a driving spring hanger or equalizer should break?
How can you tell if equalizer tubes become stopped up or broken?
Would also block the equalizerup to its proper position between the disabled end and the frame, or over the other end, as the type of spring rigging requires, to hold the equalizer level.
The above list will hopefully give you a few useful examples demonstrating the appropriate usage of "equalizer" in a variety of sentences. We hope that you will now be able to make sentences using this word.