Drill a small hole in the shaft, draw the cord taut, and fasten it through this hole.
The compass saw] One end of the turning saw can be released from the frame by removing a pin, passed through a small hole.
Make a small hole in the covering, pass a cord through, and tie it to cross the stick at its centre.
By digging in the gravelly bed of the channel, where the natives had scooped a small hole, we got some tolerable water, and were enabled to give as much as they required to our horses, but it was a slow and tedious operation.
They sometimes enter a dwelling-house through a small hole, and literally take possession, proceeding across the floor, over the walls and ceilings.
I left only a small hole, through which I could just creep in and out.
Presently I saw it run along the ground, when it entered a small hole which I had not before observed.
Looking down to the ground, towards which she was directing her alarmed gaze, I saw that it was covered by countless numbers of white ants, which came swarming in through a small hole in the wall.
The egg-cavity is very small compared with the size of the nest, some of which, look like balls of grass with a small hole in the centre.
To vignette bromide prints, the printing frame must be covered with a piece of cardboard in which a small hole (about 1-1/2 inches by 1 inch for a cabinet head and bust) is pierced.
The simplest means for getting an image is a small hole in an opaque screen.
When boring a small hole, the largest tool that will enter it without interference should be used to get the greatest rigidity possible.
This principle of dividing the error when setting work can often be applied in connection with turning and boring.
The cutters are so arranged that they all cut on the center; that is, the cutting edges lie in a horizontal plane.
When the thread tool has been fed in far enough to form a complete thread, the screw is then tested for size.
The fuse hole of the cannon is counterbored as shown and a small hole is drilled at one side to receive a small piece of copper wire, E.
When you do not have a graduate at hand, a half egg-shell with a small hole pricked in the end will serve better than a funnel.
Bore a small hole D and E in each end of the wood handle C and fasten the button parts in the holes with glue or sealing wax.
Cut a small circular plate of copper seven-sixteenths of an inch in diameter, and drill a small hole in the middle of it.
This can be done easily by first drilling a small hole, about an eighth of an inch in diameter, near one corner, and then putting a fretwork saw through it and fixing it in the frame, and sawing the metal away just inside the lines.
It would be better to make a small hole in the shaft for the point of the screw to enter.
Drill a small hole in the shaft for it, and put the screw on the end of the shaft and fix it by tightening the screw.
A small hole is then chopped with a tomahawk through the side of the stump, level with the ground and opposite the pit.
A small hole is bored near its top for the reception of the end of any hollow tube you can get; this is also secured with clay.
In a mound excavated a year or two since near Lower Sandusky, Ohio, upwards of twenty oval plates of mica of great beauty were discovered, each perforated with a small hole at one end, evidently for the purpose of suspension.
Each piece is perforated with a small hole, such as would be formed by thrusting a blunt needle through it.
From one of the ends, and communicating with the hollow of the bowl, is drilled a small hole, which answers the purpose of a tube; the corresponding opposite division being left for the manifest purpose of holding the implement to the mouth.
Some boys were playing on the mountain, when one of them found a small hole which he thought was a rabbit hole, but, pushing his arm down it, he could feel no bottom.
The son then takes up on his right shoulder an earthen pot full of water, at the bottom of which is a small hole.
At the Muharram they tie a red thread on their necks and dance round the alawa, a small hole in which fire is kindled in front of the tasias or tombs of Hussain.
Make the handle and drill a small holein it where the wheel is to be screwed on.
Drill a small hole exactly in the center of the end of the ramrod, then drive the nail thru the center of the cork and into the ramrod.
Illustration] The principle involved in the simplest and most refined forms is the same, and may be illustrated by the following experiment: Let a small hole be cut in an opaque window-shade, and the room darkened.
At the window (if there are more than one) commanding the broadest prospect have a perfectly tight, opaque screen fitted, with a small hole cut in the lower part for the insertion of the lens.
We intercept it with a screen perforated with a small hole, so that the diverging pencil which falls on the mirror may not spread too much.
The handle is hollow and air-tight, and at its upper part a small hole is drilled where the thumb or finger can readily cover it.
The above list will hopefully provide you with a few useful examples demonstrating the appropriate usage of "small hole" in a variety of sentences. We hope that you will now be able to make sentences using this group of words.
