Then lead a pipe from the end of one of the cases of the eighth mutation, through a hole bored in the block of the ninth, to meet the leaders from the vertical wheels, in order that they may be fired together.
There must be a hole bored up the centre of the nave, within half an inch of the top of the pintle.
Then, from the mouth of one of these cases, carry a leader through a hole bored slantwise in the nave, from between the spokes to the front of the block, near the spindle hole.
It consists of three pieces of wood,--a strip two feet long and two inches wide for the latch, with the ends rounded and a hole bored through it at E and another at F, as shown in Fig.
One end should be placed in the vise and the other rested upon a peg stuck in a hole bored in the side of the bench.
The Latch-string= is fastened to the latch at F, and run through a hole bored in the door above the top batten.
It consists of a glass funnel set in a hole bored in a block of wood (see A in Fig.
If nothing better is at hand, saw off a section of a broom handle, round one end and insert a handle into a hole bored in its middle.
The end of the polar axis B, that has the end turned with a shoulder, is fitted in a hole bored in the center of the hour circle.
The top end of the shaft runs in a hole bored in a brass support, B, which is screwed on the end of a piece of wood mortised in the base, as shown in Fig.
Run the top of the club through a hole bored in the stern of the centerboard.
A thin wedge driven between the two semicylindrical parts of a divided plug in a hole bored in a stone, to rend the stone.
The shaft turns in a brass tube which is fitted tightly in a hole bored in the upright.
The hanger is cut from a piece of board and has a hole bored into it the size of the handle on the fork or shovel, then a notch is sawn into the hole to pass the handle through.
The entire hanger G, with its bearings, cranks and pedals, can be procured from a discarded bicycle and fastened to the piece C; the barrel holding the bearings being snugly fitted into a hole bored in the piece with an expansive bit.
The lower end of the pipe turns in a hole bored slanting in the block.
The above list will hopefully provide you with a few useful examples demonstrating the appropriate usage of "hole bored" in a variety of sentences. We hope that you will now be able to make sentences using this group of words.
