The burner is made from a piece of brass tube, A, as is shown in the illustration, 1/2 in.
How to Make a Water Rheostat [78] A water rheostat may be made by fitting a brass tube with a cork, through which a piece of wire is passed.
Home-Made Battery Voltmeter [153] Secure a piece of brass tube 3 in.
On top of the cushion supports run a brass tube to serve the double purpose of holding the cushion down and affording something to hold on to.
This weight is made by taking a piece of brass tube, 1 inch diameter, and 4 inches long.
The roller having been provided, take a piece of brass tubeexactly so large inside that the roller will fit tightly into it, and cut off a piece the same length as the roller, or, if anything a trifle shorter.
Now take a brass tube of the same size internally as the center holes in the ends of the coil were made (3/8 inch) and push as many pieces of wire into it as are required to pack it as full as it will hold.
The current can be regulated by means of a "regulating tube," that is simply a brass tube which is made to slip over the core between it and the primary coil; the farther the tube is pushed over the core, the less powerful the shock.
The propeller-shaft is arranged within a brass tube, as shown at Fig.
If the model-builder has a small piece of brass tube on hand suitable for use in this case, it will make a much better appearing tube than the piece of wood illustrated.
The pump-cylinder is composed of a small piece of brass tube 1 inch long and 3/8 inch in diameter.
Next a piece ofbrass tube with a 1/8-inch bore and 1 inch long is cut and soldered in place for the bearing of the crankshaft.
The shaft turns in a brass tube which is fitted tightly in a hole bored in the upright.
A medium-sized and strong oilcan is used for the reservoir, the spout being cut off close to the screw part and a steel or brass tube, about 5/16 in.
On the part projecting down, a hole is drilled to receive a sleeve made of a brass tube which is soldered in place.
Next, mount a piece of brass tube, D, in the exact center of the top and perpendicular to it.
The objective is also formed of two lenses fitted into a brass tube with a diaphragm in front.
Brass tube, from two inches to six inches in diameter, cut in lengths suited for boilers, is sold by most of the model engineers.
The above list will hopefully provide you with a few useful examples demonstrating the appropriate usage of "brass tube" in a variety of sentences. We hope that you will now be able to make sentences using this group of words.
