The chamfers with the grain should be planed before those across the grain.
Chamfers of this kind are used on a small scale and in delicate work: the coarse chamfers are found on all scales: f and g, Fig.
Q A produced: and also of all chamfers in straight lines, as a b, e f.
I have placed in the Appendix[73] a figure belonging to this subject, but which cannot interest the general reader, showing the number of possible chamfers with a roll moulding of given size.
A B representing the chamfers and C the oil hole, the two brasses put together appearing as shown in section in Fig.
Eighth operation: Front tool in the carriage chamfers off the end thread.
Then, with the knife, shave off the corners so as to make four symmetrical chamfers throughout.
With the knife, make the chamfers at the corners of the curves, as shown in Fig.
The chamferson ribbed bodies are gone over with the filler.
The day following, the surface is given an application of knifing-in lead, the chamfers getting the same treatment as the flat surface.
If the grain of the wood is straight, the chamfers can be whittled easily; if it is crooked watch that it does not split over the line.
After the chamfers are made, pare another one 1/8" wide around the end of the handle.
It may be used wherever square edges are to be made, but chamfersand bevels should be marked with a pencil.
After planing the post to size, lay out the chamfers (see page 32) with a pencil on all four sides.
The above list will hopefully give you a few useful examples demonstrating the appropriate usage of "chamfers" in a variety of sentences. We hope that you will now be able to make sentences using this word.
